Changes to Step #72
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [* black] You can now mount the internal components you've completed to the shell of the ROV. This is best done with the ROV up-side-down. |
| [* black] Rout the wire harness through the opening in the main bulkhead on the starboard side of the ROV. |
| [* black] Place the internal structure into the shell and allow the tabs of the internal structure to click into place. |
| [* black] Move the two battery tubes so that they are resting forward of the bulkhead. This will position them in the correct place once the threaded rods are put in. |
| [* black] Add one non-locking M5 nut to each end of each threaded rod, about 1cm in from each end. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added