Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #12

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Sand both cut ends of resulting pieces to smooth the edgesand square the edges
[* black] Sand both cut ends of resulting pieces to smooth the edgesand square the edges
[* black] Use hex wrench or screwdriver to debur and remove particles from inside tube - you want to make sure the syringe plunger can easily re-enter the tube
[* icon_note] Try not to scratch the inside of the syringe while deburing the edges- you'll want this to be pretty smooth so there are no paths for water to leak around the plunger
[*
icon_note] Blowing in the tube or wiping the inside with a Q-tip or piece of paper towel may also help remove particles
[* icon_note] Try not to scratch the inside of the syringe while deburing the edges- you'll want this to be pretty smooth so there are no paths for water to leak around the plunger
[*
icon_note] Blowing in the tube or wiping the inside with a Q-tip or piece of paper towel may also help remove particles