Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #69

Edit by Rob

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Once the potting in the main endcaps has cured, you can attach the DB-25 connector to the end of the wire harness.
[* black] Start by removing the tape that was used to hold the bundle together
[* black] Next, measure a distance of 17cm from the inside surface of the endcap, and cut one of the wires from the bundle at that length. Measure twice, cut once- you don't want the harness to be too long or twotoo short by more thenthan about 1cm!
[* black] Next, measure a distance of 17cm from the inside surface of the endcap, and cut one of the wires from the bundle at that length. Measure twice, cut once- you don't want the harness to be too long or twotoo short by more thenthan about 1cm!
[* black] Use the one wire that you've cut as a guide to cut all the remaining wires in the bundle to the same length