Changes to Step #69
Edit by Dominik Fretz —
Edit approved by Dominik Fretz
- Before
- After
- Unchanged
Step Lines
[* black] Once the potting in the main endcaps has cured, you can attach the DB-25 connector to the end of the wire harness. |
[* black] Start by removing the tape that was used to hold the bundle together |
[* black] Next, measure a distance of 17cm from the inside surface of the endcap, and cut one of the wires from the bundle at that length. Measure twice, cut once- you don't want the harness to be too long or two short by more then about 1cm! |
[* black] Use the one |
[* black] Use the one |