Changes to Step #69
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [* black] Once the potting in the main endcaps has cured, you can attach the DB-25 connector to the end of the wire harness. |
| [* black] Start by removing the tape that was used to hold the bundle together |
| [* black] Next, measure a distance of 17cm from the inside surface of the endcap, and cut one of the wires from the bundle at that length. Measure twice, cut once- you don't want the harness to be too long or two short by more then about 1cm! |
| [* black] Use the one ware that you've cut as a guide to cut all the remaining wires in the bundle to the same length |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added