Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #68

Edit by Eric Stackpole

Edit approved by Eric Stackpole

Before
After
Unchanged

Step Lines

[* black] Next, plug the servo into the controller board (D-11). It tendsboard. Plug into D-11 on the end of the header set (the photo shown is now out of date and needs to be a fairly tight fit, but will go on with a little finaglingretaken). Remember, the "signal" line (the yellow wire) should go over the inner pin closest to the Beaglebone.
[* black] Next, plug the servo into the controller board (D-11). It tendsboard. Plug into D-11 on the end of the header set (the photo shown is now out of date and needs to be a fairly tight fit, but will go on with a little finaglingretaken). Remember, the "signal" line (the yellow wire) should go over the inner pin closest to the Beaglebone.
[* black] You can also plug the LED array into the Controller Board. The black and red wires go into headers "P1-" and "P1+" respectively as shown.