Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #68

Edit by Brian Adams

Edit approved by Eric Stackpole

Before
After
Unchanged

Step Lines

[* black] Next, plug the servo into the controller boardboard (D-11). It tends to be a fairly tight fit, but will go on with a little finagling. Remember, the "signal" line (the yellow wire) should go over the inner pin closest to the Beaglebone.
[* black] Next, plug the servo into the controller boardboard (D-11). It tends to be a fairly tight fit, but will go on with a little finagling. Remember, the "signal" line (the yellow wire) should go over the inner pin closest to the Beaglebone.
[* black] You can also plug the LED array into the Controller Board. The black and red wires go into headers "P1-" and "P1+" respectively as shown.