Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #63

Edit by Brian Adams

Edit approved by Eric Stackpole

Before
After
Unchanged

Step Lines

[* black] Place the BeagleBone PlackBlack down onto the large male headers built into the controller board.
[* black] Place the BeagleBone PlackBlack down onto the large male headers built into the controller board.
[* icon_caution] Be sure the header pins are aligned properly with the holes on the BeagleBone Black, and that the Ethernet jack on the BeagleBone Black is facing away from the ESCs
[* black] Plug the other end of the Ethernet Jumper into the port on the BeagleBone Black.
[* black] Use an additional M3 screw to fasten the BeagleBone Black to the standoff coming out of the Controller Board