Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #57

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Now you have both parts of the E-ChassisE-Chassis and a controller board that's ready for external electronics. Nice job! Next, we're going to attach the lights and camera to the Camera Platform.
[* black] Now you have both parts of the E-ChassisE-Chassis and a controller board that's ready for external electronics. Nice job! Next, we're going to attach the lights and camera to the Camera Platform.
[* black] Start by soldering the two light panels together. To do this, you'll want to create a small solder blob on the pads on the far left and right of one of the light panels, then attach the leads from the other light panel so that the red wire you're attaching is on the same side as the red already-attached wire (and the same for black).
[* black] Apply a small amount of super glue between the two notches in the Camera Platform and place a light panel there. The light panel should be positioned so that its leadwires are aligned with one of the notches, and it should be centered vertically.
[* icon_caution] If the light panel is too high or too low, the electronic components on the panel may rub against the Electronics Tube.