Changes to Step #10
Edit by Eric Stackpole —
Edit approved by Eric Stackpole
- Before
- After
- Unchanged
Step Lines
| [* red] In the next steps you will be cutting the syringe in two places (indicated by the two red arrows) |
| [* black] Place syringe in vice with end protruding out |
| [* black] Cut off end just past where plunger stop is located |
| [* icon_caution] you want to leave the endstop for the plunger in place. Look at the third photo! [* black] The part you'll want to keep is the piece that was between the two cuts. You'll also want to keep the white syringe plunger (we'll use that later). You can discard the very front part of the syringe as well as everything above the 1.5mL cut. |
| [* icon_caution] you want to leave the endstop for the plunger in place. Look at the third photo! [* black] The part you'll want to keep is the piece that was between the two cuts. You'll also want to keep the white syringe plunger (we'll use that later). You can discard the very front part of the syringe as well as everything above the 1.5mL cut. |