Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Insert wisdom hereThe Bulkhead and Motor Mount assembly can now be placed down onto the Top Plate of the ROV.
[* black] Once again, be sure to bond any interfaces that have been created.
[* black] The Tube Cradle pieces can now be built. Two pieces are used for each of the two cradles. Just as you did with the handle pieces, it is recommended that you stagger the pieces in order to guide the syringe and cement, but be sure to align the pieces before the cement sets!
[* black] Place the Tube Cradle Assemblies into place and cement them to the rest of the internal structure. Be sure there is a good cement bond near the ends of the cradles as these areas will be under significant strain when securing the main tube later on
.
[* black] Insert wisdom hereThe Bulkhead and Motor Mount assembly can now be placed down onto the Top Plate of the ROV.
[* black] Once again, be sure to bond any interfaces that have been created.
[* black] The Tube Cradle pieces can now be built. Two pieces are used for each of the two cradles. Just as you did with the handle pieces, it is recommended that you stagger the pieces in order to guide the syringe and cement, but be sure to align the pieces before the cement sets!
[* black] Place the Tube Cradle Assemblies into place and cement them to the rest of the internal structure. Be sure there is a good cement bond near the ends of the cradles as these areas will be under significant strain when securing the main tube later on
.