OpenROV
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Eric Stackpole —

Edit approved by Eric Stackpole

Before
After
Unchanged

Step Lines

[* black] Now,Now the Bulkhead piece can be added.
[* black] Now,Now the Bulkhead piece can be added.
[* black] Be sure to get cement between every interfacing joint.
[* blackred] Once the Bulkhead is secured, the Bulkhead Brace can be attached. Be sure to areas around the outside tabs are cemented well, as voids may cause the tabs to break off more easily if the ROV is handled roughly.
[* blackred] Once the Bulkhead is secured, the Bulkhead Brace can be attached. Be sure to areas around the outside tabs are cemented well, as voids may cause the tabs to break off more easily if the ROV is handled roughly.
[* icon_note] In newer kits, the width of the plastic adjacent to the tabs is greater then what's shown in the photo.
[* icon_note] Occasionally, the extra bits of plastic from inside the holes on the bulkhead will not have fallen out during the laser process. If this is the case, a small amount of finger pressure should be sufficient to remove them to be discarded.

Image 2

Old Version

New Version