Changes to Step #48
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [* black] While the E-90 is still fluid, you'll want to attach propellers to the motor bells for each thuster. Start by sanding the shaft of each motor bell using a medium-grit (we used 150-grit) sand paper. |
| [* black] Cut off three 4mm long pieces of the adhesive-lined shrink tubing that was also used on the motor |
| [* black] Cut off three 4mm long pieces of the adhesive-lined shrink tubing that was also used on the motor |
| [* black] Slide one of the pieces of shrink tubing down to the root of each shaft and shrink it down until it is secure using a heat gun. |