Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #48

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Insert wisdom hereWhile the E-90 is still fluid, you'll want to attach propellers to the motor bells for each thuster. Start by sanding the shaft of each motor bell using a medium-grit (we used 150-grit) sand paper.
[* black] Cut off three 4mm long pieces of the adhesive-lined shrink tubing that was also used on the motor leads
[* black] Slide one of the pieces of shrink tubing down to the root of each shaft and shrink it down until it is secure using a heat gun
.
[* black] Insert wisdom hereWhile the E-90 is still fluid, you'll want to attach propellers to the motor bells for each thuster. Start by sanding the shaft of each motor bell using a medium-grit (we used 150-grit) sand paper.
[* black] Cut off three 4mm long pieces of the adhesive-lined shrink tubing that was also used on the motor leads
[* black] Slide one of the pieces of shrink tubing down to the root of each shaft and shrink it down until it is secure using a heat gun
.