Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #43

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Insert wisdom hereIn this step, we'll add the white flange cover to the the endcap. Position the flange cover so that its flat edge is aligned with that of the main flange plate.
[* icon_note] Be sure the spread out the wires in the harness so that they do not push the flange cover out.
[* black] Inject cement between the two plates in a similar way to how the other parts of the endcap were assembled.
[* black] After sufficient cement has been injected between the plates, push the assembly down against a table to spread the cement across the interface.
[* icon_caution] Be sure the flange cover and main flange plate stay concentric and aligned as the cement sets
.
[* black] Insert wisdom hereIn this step, we'll add the white flange cover to the the endcap. Position the flange cover so that its flat edge is aligned with that of the main flange plate.
[* icon_note] Be sure the spread out the wires in the harness so that they do not push the flange cover out.
[* black] Inject cement between the two plates in a similar way to how the other parts of the endcap were assembled.
[* black] After sufficient cement has been injected between the plates, push the assembly down against a table to spread the cement across the interface.
[* icon_caution] Be sure the flange cover and main flange plate stay concentric and aligned as the cement sets
.