Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #38

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Find the shortest leadwire in the bundle (it should be the wire coming from the button terminal on the port battery tube) and make sure that it's end is at least 18cm from its length mark.
[* black] Trim the ends off of all the remaining wires so that they end at the same place as the shortest wire.
[* black] Wrap tape aroundWith the setremaining 20awg wire, cut six 60cm long leads and group them together. These will be used as the auxiliary wires for connecting external devises to the ROV
[* black] Pull one
of the ends inout from the coil of twisted pair "tether" wire and group it so that it is flush with the ends of the newly cut auxiliary wires.
[* black] Align the ends of the the tether and auxiliary wires with the ends of the motor and battery leads and wrap tape around
the whole bundle. This tape cover will help guide the bundle through the mesh sleeve that will be used several steps later.
[* black] Wrap tape aroundWith the setremaining 20awg wire, cut six 60cm long leads and group them together. These will be used as the auxiliary wires for connecting external devises to the ROV
[* black] Pull one
of the ends inout from the coil of twisted pair "tether" wire and group it so that it is flush with the ends of the newly cut auxiliary wires.
[* black] Align the ends of the the tether and auxiliary wires with the ends of the motor and battery leads and wrap tape around
the whole bundle. This tape cover will help guide the bundle through the mesh sleeve that will be used several steps later.