Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #33

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Cut three 3cm-long lengths of black 3M EPS-300 (adhesive-lined) shrink tubing
[* black] Slide one of the 3cm lengths of adhesive shrink tubing down each of the newly attached leadwires. Make sure the shrink tubing is slid all the way down the leadwire and over the solder joint until it can't slide any furtherbottoms out at the stem of the magnet wire from the motor.
[* black] Shrink the tubing with a heat gun. 3Mgun until the inner lining oozes out its ends.
[* icon_note] 3M
EPS300 seems to need a little more time and heat to fully shrink. Look for the adhesive lining to ooze out the edge of the shrink tubing.
[* black] Slide one of the 3cm lengths of adhesive shrink tubing down each of the newly attached leadwires. Make sure the shrink tubing is slid all the way down the leadwire and over the solder joint until it can't slide any furtherbottoms out at the stem of the magnet wire from the motor.
[* black] Shrink the tubing with a heat gun. 3Mgun until the inner lining oozes out its ends.
[* icon_note] 3M
EPS300 seems to need a little more time and heat to fully shrink. Look for the adhesive lining to ooze out the edge of the shrink tubing.