Changes to Step #29
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [* black] In this section, we're going to attach longer leads to each of the three motors and waterproof their solder junctions with special adhesive-lined shrink tubing. It will be helpful to have the tools and materials shown in the photograph. |
| [* black] To start out, we'll need to remove the motor bells. In order to do this, we'll have to remove the c-clips that retain them by spreading the c-clips open and off off with the outside edges fine-tipped needle nose pliers. |
| [* icon_caution] The c-clips sometimes pop of with a lot of speed, so it's a good idea to wear saftey glasses to protect your eyes! |
| [* black] If you don't have any fine-tipped needle nose pliers laying around, a flat-head screwdriver can also be used, but this is a bit more tricky. |
| [* icon_note] After removing the C-Clips, they can be disguarded . You won't need them any more, so don't worry if they break! |