Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] We'll start out by assembling the ROV handle
[* black] The pieces you got likely came with a protective plastic backing on them. You'll need to peel this off of each piece before cementing it to anything
[*
black] Cement two of the three handle pieces together
[* icon_note] It's best to stagger the pieces to help guide the applicator syringe to the interface between themthem. The cement sets quickly though, so be sure to align the pieces with each other while they can still move.
[* black] The pieces you got likely came with a protective plastic backing on them. You'll need to peel this off of each piece before cementing it to anything
[*
black] Cement two of the three handle pieces together
[* icon_note] It's best to stagger the pieces to help guide the applicator syringe to the interface between themthem. The cement sets quickly though, so be sure to align the pieces with each other while they can still move.
[* black] Once the first two handle pieces are attached, add the third
[* black] This is a good moment to fillet the handle (now comprized of three pieces) using sand paper so it will be nicer to hold on to once the ROV is built
[* black] This is a good moment to fillet the handle (now comprized of three pieces) using sand paper so it will be nicer to hold on to once the ROV is built