Changes to Step #23
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [* black] Next, we'll glue the disks for the forward endcap. This is where the motor bell comes in- we're going to use it as a centering pin |
| [* black] Slide the larger forward endcap disk (28mm diameter) over the motor bell. Then slide the smaller one (24mm diameter) on. It will be a very tight fit. Cement them together. |
| [* black] Take another large endcap and sandwich the smaller one. Cement it in place. |
| [* black] Attach and cement the outer forward battery endcap disk. |
| [* icon_note] Visually inspect that the shaft going through the disks is perpendicular to them- although the fit is tight, it is still possible for the shaft to end up somewhat angulated |
| [* black] Sand a corner of the button terminal (any corner of the button terminal - on button side) |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added