Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #22

Edit by Eric Stackpole

Edit approved by Eric Stackpole

Before
After
Unchanged

Step Lines

[* black] Align and glue outer and middle disks of aft endcap. It’s important that it lines up correctly - the nub of the middle disk accenting the hole on the outer disk.
[* black] Measure out 25cm of wire length passing through the spring terminal endcap. (Good idea to make a reference mark on the wire near the base of the terminal.
[* black] Slip the middle and outer disks over the longer length of wire. Both wires through the middle hole.
[* black] Double check that the wire is 25cm (once it’s gluedthe disks are cemented together, it’s very hard to pull itthe wire in or out).
[* black] Double check that the wire is 25cm (once it’s gluedthe disks are cemented together, it’s very hard to pull itthe wire in or out).
[* black] Make sure the inner, middle, and outer disks are concentric (visual). Then glue them together.