Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Jonny Teague

Edit approved by Jonny Teague

Before
After
Unchanged

Step Lines

[title] Wiring Mounting Holes
[* black] New holes need to be drilled to cable tie the new wiring to the Frame. I used a 3mm drill bit but as i had small cables ties
[* black] Holes need to be drilled two above and below the connector for the case to attach. On the 2.6 its a kind of rounded piece with pegs on.
[* black] The holes should be the same distance and the width of the cable so place the cable up to the acrylic and mark with a marker pen
[* black] For the Middle section you should be able to find existing holes in the frame that allow cable ties (shown in 2nd and 3rd picture)

Image 1

Old Version

New Version