Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Jonny Teague

Edit approved by Jonny Teague

Before
After
Unchanged

Step Lines

[title] Mother Board
[* black] The new configuration of the 2.8 system requires the vertical DB25 to be horizontal.
[* black] So in order to do this the old one must be removed this can be one of two ways
[* black] 1. Take a hacksaw and carefully cut the whole thing off leaving only the pins of the DB25. Which can then be unsoldered.
[* black] 2. Try to unsolder the vertical DB25 connector by unsoldering each connection with a solder sucker and then take the whole thing off. This takes a lot longer and is generally harder than the first method but potentially a lot better for the electronics board.
[* black] Solder on the new horizontal DB25 connector