Changes to Step #25
Step Lines
[* black] Use scissors to cut off left over frayed ends of the sleeve material up to the electrical tape. |
[* black] Thread the wiring harness through the Port endcap. The harness should go from the outside of the endcap, inward. You can make sure you're going through the correct endcap by placing it in the position as shown. In this position, the flat edge of the endcap should face toward the port battery tube. |
[* black] During this step, we'll measure out the right length of wiring harness so that it is not too tight or too loose when the endcap is in place. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added