Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by Zack

Edit approved by Zack

Before
After
Unchanged

Step Lines

[* black] Now we're going to start cementing the endcap disks together.
[* black] The first two pieces you'll cement together are the 3mm-thick disk and the 6mm-thick disk with a smaller hole in the center.
[* black] The 3mm-thick piece will end up being the inner-most disk of the endcap. Place the syringe section in the centering holes of the two disks so that the plunger stop-end of the syringe section is facing the inner disk.
[* black] You may also notice small notches extending from one side of the inner disk (a result of the laser-cutting process). Ideally these notches should face inward (away from the 6mm disk) as they may make it harder for the o-ring to seal properly.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added