Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Zack

Edit approved by Zack

Before
After
Unchanged

Step Lines

[* black] SAME PROCEDURE FROM 2.6 BUILD GUIDE
[* black] Cut quantity 9 pieces of waterproof heat shrink tubing, length should be 2-3cm.
[* black] Apply a small amount of hot glue to the joint as shown.
[* black] With the hot glue still warm, slide the heat shrink tubing over the joint.
[* black] Make sure the pieces of shrink tubing are slid all the way up the wires so that each solder joint is completely covered.
[* black] Heat the tubing with a heat gun until the gel lining and hot glue inside oozes out from the tubing on both sides.