Changes to Step #8
Step Lines
[* black] SAME PROCEDURE |
[* black] SAME PROCEDURE |
[* black] Cut quantity 9 pieces of waterproof heat shrink tubing, length should be 2-3cm. |
[* black] Apply a small amount of hot glue to the joint as shown. |
[* black] With the hot glue still warm, slide the heat shrink tubing over the joint. |
[* black] Make sure the pieces of shrink tubing are slid all the way up the wires so that each solder joint is completely covered. |
[* black] Heat the tubing with a heat gun until the gel lining and hot glue inside oozes out from the tubing on both sides. |