Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Zack

Edit approved by Zack

Before
After
Unchanged

Step Lines

[* black] First we're going to remove the internal structure from the frame for easier access.
[* black] Remove the electronics chassis from the acrylic main tube and disconnect the DB25 cable
[* black] Cut away the zip ties that hold the wires to the internal structure.
[* black] Cut the tether away, leaving as much on the bundle or spool side as possible.
[* black] Cut the battery tube wires about 10cm from the rear end of the battery tube as shown.
[* black] Remove the motor-bells/props.
[* black] You should have something looking like the last picture here, a free frame and two free battery tubes.