Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Zack

Edit approved by Zack

Before
After
Unchanged

Step Lines

[* black] First we're going to remove the internal structure from the frame for easier access.
[* black] Remove the electronics chassis from the acrylic main tube and disconnect the DB25 cable
[* black] Cut away the zip ties that hold the wires to the internal structure.
[* black] Cut the tether, leaving as much on the bundle or spool side as possible.
[* black] Cut the battery tube wires about 10cm from the rear end of the battery tube as shown.
[* black] Remove the motor-bells/props.
[* icon_caution] Cut the motor wires as shown. Be careful to not cut the wires on the motors so short that you cut away the enameled wire that is underneath the heatshrink...as we will resolder this to the new wires.
[* black] You should have something looking like the last picture here, a free frame and two free battery tubes.