Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #97

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Bevel the inner edges of the main tube using a medium grit sandpaper so that the o-ring will fit in the tube without getting damaged by the sharpness of the tube's inner edge.
[* black] Wipe off all the dust left over from the sanding process when done.
[* black] '''Do not scratch the inside of the tube. ''' This is where the o-ring seals (see steps below).