Introduction
Often times it is difficult to create a waterproof electrical connection that will survive underwater. Traditional methods include potting, which takes a long time to set, or using underwater connectors, which can be expensive. Through much lab and field testing we have found that connections can be done in a short amount of time and in a cheap way using adhesive lined heat shrink. These steps will walk you through the process.
-
-
You are going to want to cut each piece of heat shrink so it is about 5mm longer than the solder joint on either side
-
-
-
It is best to tin each wire before joining them.
-
You want to avoid sharp points on your solder connection, or frayed wire.
-
-
-
-
Team
