Introduction
This How-to should guilde you through the steps of upgrading your motorshafts to M5 threads.
-
-
-
Apply a bit of Loctite to the outter side of the motorshaft and push the threated adapter over the shaft of the motor
-
Wait for the Loctite to cure (in my case waiting about an hour did the job)
-
After the Loctite has cured screw the M5 nut almost all the way down (see picture 2)
-
Screw in the Propeller and counter it with the M5 nut (see picture 3)
-
Cancel: I did not complete this guide.
One other person completed this guide.